Musical Fidelity A3.2 Specifications download pdf (Page 5)

A3.2

CR

Power Instructions for Use Page 5 of 7

All input, output and power connections

should be made with the mains power

switched OFF.

INPUT CONNECTIONS

The A3.2

CR

Power amplifier can be used

with a preamplifier or any line level source

which has a volume control. We highly

recommend the matching A3.2

CR

pream-

plifier available from Musical Fidelity.

Connect the left and right outputs from

your pre-amp or other line level source to

the RCA inputs on the back panel marked

as LEFT and RIGHT Line Inputs. The

corresponding LOOP OUTPUT sockets

are directly connected inside the unit to

duplicate the line inputs. This is to enable

onward connection to another amplifier, for

example when used for “bi-amplification”.

For the best results we recommend that

you use either Musical Fidelity X-LINX

“no-nonsense” cables for this connection or

the highly rated Nu-Vista interconnects

with integral RFI suppression. Various

lengths are available in the Nu-Vista inter-

connect range.

LOUDSPEAKER CONNECTIONS

Connect your loudspeakers to either of the

two pairs of loudspeaker terminals situated

on the back panel marked as LEFT and

RIGHT SPEAKER OUTPUT. The

wiring must be “in phase”, namely, the +

and - terminals must be connected to the

left and right speakers the same way round.

Note: - the combined load impedance

must not be less than 4 ohms.

Issue 1: April 2002

BEFORE SWITCHING ON. . . . .

Plug the accessory IEC mains lead into the

rear panel socket, then the other end into a

convenient wall outlet.

Turn the volume control on your preampli-

fier to minimum, and switch on its power.

OPERATION

Press the POWER switch on the front

panel of the A3.2

CR

- the red POWER

LED will light to confirm that the unit is

ready for use.

Select the required audio input source on

your pre-amplifier, and advance the volume

control to obtain the preferred sound level.

CONNECTIONS and OPERATION

1 2 3 4 5 6 7

Comments to this Manuals

No comments