Musical Fidelity M3I Specifications download pdf (Page 12)

M3i manual issue 1 Page 12 of 13

SPECIFICATIONS

Output

Power 76 Watts per channel into 8 Ohms (19dBW)

Voltage 25 Volts RMS, 20Hz to 20 kHz; onset of clipping

70 Volts peak to peak

Current 25 Amps peak to peak

Damping factor 36

Output devices 1 pair per channel

Line input

THD+N < 0.014 % typical, 20Hz to 20 kHz

Signal / noise ratio > 96dB ‘A’-weighted

Input impedance 40 k Ohms

Frequency response +0, –0.1dB, 10Hz to 20 kHz

Connections

Line level inputs 6 pairs line level RCA connectors

Line level outputs 1 pair line level RCA connectors, constant level TAPE outputs

1 pair line level RCA connectors, preamp outputs for e.g. biamping

Speaker outputs 2 pairs 4mm banana plug/binding posts

Power requirement

Mains voltages 115/230VAC 50/60Hz (factory pre-set)

100VAC 50/60Hz (alternative)

Consumption 320 Watts maximum

Weight

Unit only, unboxed 9.2 kg (20¼ lbs)

In shipping carton 13 kg (30⅔ lbs)

Dimensions

Wide 440 mm (17⅓”)

High, including feet 100 mm (4”)

Deep (front to back) including terminals 400 mm (15¾”)

Standard accessories

IEC type mains lead (10-Amp type)

M3i remote control

Batteries, LR03 or AAA, manganese alkaline type - 2 off

Musical Fidelity reserves the right to make improvements which may result in

specification or feature changes without notice.

1 2 ... 7 8 9 10 11 12 13

No comments

Musical Fidelity M3I Specifications Page 12