Musical-fidelity KW250S User Manual download pdf (Page 13)

KW250S

CD SPECIAL FEATURES

Issue 3: 12th July 2006

Page 13

INVALID TRACK

program 2 track 9

PLAY 1 0:41

play program

Remember that when entering a single-digit track number,

there is a delay of about two seconds before the display

accepts the entry - this is to allow time for a second button to

be pressed when a double-digit number is required.

If an incorrect entry is made, say track 99 when there are only

7 tracks available on the disc, a brief error message is

displayed

If at any time you wish to add a track to the list, press the

CLEAR button to obtain the next step number. Alternatively,

to delete a previous entry, press CLEAR a second time to

remove the last entry. Repeated pressing of CLEAR will

then erase each step in reverse order. So to delete an entire

program sequence from the memory, press CLEAR

repeatedly until “prog 1” is shown in the display.

When the last track number has been entered, press

PROGRAM a final time, then the PLAY button to start the

program sequence.

If you wish to check the selection before playing back your

program, the CHECK button can be pressed to step through

each program entry in turn.

If during this check sequence the PLAY button is pressed, the

remaining part of your programmed selection will play to the

end of the sequence.

Otherwise, to play all the programmed tracks from the

beginning of the sequence, press PLAY/PAUSE, or PLAY

on the remote control.

The >>| button may be pressed to jump to the next track in

the programmed sequence, or

|<< button to obtain the previous track in the sequence.

When all programmed tracks have been played, the CD player

stops. The same track selection can then be played again by

pressing the PLAY/PAUSE button on the front panel, or

PLAY on the remote control.

To repeat a programmed sequence continually, press

REPEAT whilst playing the program.

To cancel this mode, press PROGRAM.

Note: The program contents will be cleared if you switch off

the power, or open the disc drawer and load another disc.

If, however, the same disc is loaded again with the power

still switched on, the program sequence is retained in the

memory.

DISPLAY

KW250S display brightness can be controlled in three

levels by pressing the DISPLAY button on the remote

control.

The original setting is maximum brightness, but by pressing

the DISPLAY button once, brightness is reduced, and a

further press turns the display off. This controls display in

CD, TUNER, and external source modes.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 24 25

Comments to this Manuals

No comments

Musical-fidelity KW250S User Manual Page 13

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Musical-fidelity KW250S